Quiver Killer Binding Inserts are threaded metal inserts for ski binding mounting holes that once installed & with the bindings screws exchanged for M5 machine screws, allow the bindings to be removed/reinstalled as often as you like - just like snowboard bindings. The inserts are made from non rusting stainless steel & have a closed end to give a water tight seal when epoxied to the skis core. The course outer thread grips the skis core whilst the fine rolled inner thread gives the M5 bindings screws a metal to metal fixing to the ski, all of which combines to give a mount that's over 40% stronger than a conventional binding mount.
Benefits:
- save cost by sharing bindings across other skis
- reduces bulk/weight for travelling
- switch between alpine & touring bindings on the same skis
- bindings quickly removed & reinstalled with just a no.2 pozi driver
Tech Facts:
- Outer thread: 5/16-18
- Inner thread: M5
- Overall length: 8.25mm (can be shortened to 7.55mm by filing material off the closed end if required))
- Inner thread depth: 6.2mm
- Weight: 1.1g
Quiver Killer Binding Inserts are available to purchase below for your own installation and Jon is always available to give advice (having personally installed over 2000 sets!) or see details of Jon's installation service within the 'Binding Mounting & Quiver Killer Inserts' tab found on the top banner.
Quiver Killer Rescue Inserts are the same as the regular insert above but with a larger 11mm+ outside diameter for that "oh shit" moment as they're perfect for repairing a pulled-put binding screw (better & easier than a heli-coil) or for if you cock-up a Quiver Killer installation and need to replace an insert that's been installed a bit off line. The Rescue insert has the same M5 inner thread as a regular Quiver Killer insert but with a lot larger diameter to allow it to 'encapsulate' the damaged area or an out-of-location insert etc. The Rescue inserts can be DIY installed or see details of Jon's installation service within the 'Binding Mounting & Quiver Killer Inserts' tab found on the top banner.
For Trade and Bulk Quantities please contact Jon with your requirements.
